How To Retrofit 2017 Golf Alltrack SEL Virtual Cockpit AID 5G1 920 791


Everything you needed to Retrofit 2017 Golf Alltrack SEL Virtual Cockpit AID 5G1 920 791
Thanks for the Car Case Experience sharing from “bbusato”


If you haven’t connected the fiber optic cable, hook up VCDS and create a complete mapping for modules 17 and 5F for later reference. Begin by removing the interior trim piece with the air vents that go around the touch screen. Start at the bottom and slowly work your way up. You’ll have to remove the air vent on the driver side near the door first to be able to remove the trim that goes around the cluster. I found it easier to pull out the headlight switch then remove the single screw holding the trim that goes around the headlight and dimmer switches so I could push out the air vent with my hand. The cluster itself is held in place by 4 really hard to pull clips and 2 Torx screws on the bottom. Lower the steering wheel column all the way down and gently pull the horizontal plastic trim piece at the bottom of the cluster out towards you. Below video might be helpful:

Once all trim is carefully removed and you unscrew the 2 screws at the bottom of the cluster, pull the old cluster out if you can. This is really hard to do and you will need gloves to get a good grip. Next, you will need to remove your MIB2 head unit in the glove box, disconnect all wires in the back, remove your touch screen and run the splitter cable from the glove box to the opening behind where the cluster is located. I ran a piece of wire through the MIB2 opening slot then through an opening immediately to the top and guided it towards the air vent opening in the center of the dash.
Golf IC Trim Remove

If you are not able or don’t want to remove the old cluster yourself, then just run the fiber optic cable as close to the cluster as you can and your VW tech should be able to easily pull it through for you after he takes out the old cluster. Have your local VW dealership code the AID to your car and immobilizer using ODIS and be sure to take both your keys with you. Also, make sure you reconnect module 5F (MIB2) to the car again before ODIS coding to avoid any issues with your coding. I accidentally left mine unplugged and had to run ODIS twice because of that. This is what your new digital cockpit will look like after coding with ODIS. It will be functional, but the graphical representation of the car will be a regular Golf, not Variant/SportWagen, and the display depiction will also be the one for the Golf Trendline:
5G1 920 791

Coding with VCDS

  1. Go to Module 17, Coding, Long Coding Helper, Byte 2, Bit 3-6 and change it to 50 Model: Variant A (stock setting is 10 Model: Variant 2):
Coding with VCDS
Coding with VCDS 01

2. Go to Byte 12 and check the box for Bit 2 – Alternative Dimming Function active:

Coding with VCDS
Coding with VCDS 02

3. go to Adaptations and choose the channel Display depiction and change it from Version 1 to Version 2 (this will enable NAV in the AID screen; Version 1 doesn’t support it. I couldn’t figure out why my navigation map would not show up on the AID after everything was enabled and it was all because of this setting)
Then go to Tube_version and change the channel setting to variant_2 to get the AID speedo and tach versions specific to the Alltrack:
4. Open module 5F and open Long Coding Helper; go to Byte 22 and uncheck Bit 0 – Instrument Cluster Graphics [STANDARD]:

Coding with VCDS
Coding with VCDS 03

OPTIONAL: If you don’t use the AM band on your radio and you’d like to be able to toggle between FM and Satellite only, tick the box for Bit 3 in Byte 14:

Coding with VCDS
Coding with VCDS 04

5. Go to Adaptations in Module 5F and change the following channels to the settings below:
Dashboard_Display_Configuration-ability_switch_nav_maps —> On (enables the toggle switch on the touch screen)
Dashboard_Display_Configuration-call_picture —> On
Dashboard_Display_Configuration-fastlist_most —> On
Dashboard_Display_Configuration-navigation_map_compression_mode —> H264
Dashboard_Display_Configuration-navigation_map_transmission_mode —> MOST_streaming

That’s it! Enjoy driving your Alltrack with its new, fully functional digital dash!

Golf 5G1 920 791


Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Select the fields to be shown. Others will be hidden. Drag and drop to rearrange the order.
  • Image
  • SKU
  • Price
  • Stock
  • Availability
  • Add to cart
  • Description
  • Content
  • Additional information
  • Attributes
Click outside to hide the compare bar